New molds finished and tested

Hello everyone, I have been working during the last days into the new molds and finally I finished to make them all. As I explained in my previous post, some parts that were more complex to cast than others, were splitted to make an easier cast and therefore having better molds which result in a quicker and easier work. I have made a test with the FMC15i cargo loader with the new molds, these don’t change the final aspect, but this was needed to check if all the parts from the new molds fitted well as this is one of …

New molds finished and tested Read More

WiFi radome

Hello, I have been able to complete the new molds of the 1/144 catering truck and the 1/144 pushback truck, there are still the cargo loader molds and GPU molds to be made. Making the molds may be a little time consuming thus I did not have much time to advance with the B737NG cabin project on the weekend. With less time, I decided to make a new WiFi radome; this WiFi radome is mainly seen on B777, A350, B787, B767 and also on smaller airliners such as the B757, B737 and A319/A320/A321. The one that I tried to represent …

WiFi radome Read More

Making new molds

Hi all, I am writing this entry to comment on the stock of the older GSE models. As you may probably know, sometimes molds can break or deteriorate with time because of several reasons; use, humidity etc. So right now I am in a transition process in which I am making new molds for the following items: 1/144 Towbarless pushback. 1/144 Catering truck. 1/144 Cargo loader FMC15i. 1/144 Ground power unit. 1/144 LD3 containers. I am obliged to make them new because using old molds means that there is going to be a loss of detail, so it should be …

Making new molds Read More