WiFi radome

Hello,

I have been able to complete the new molds of the 1/144 catering truck and the 1/144 pushback truck, there are still the cargo loader molds and GPU molds to be made.

Making the molds may be a little time consuming thus I did not have much time to advance with the B737NG cabin project on the weekend. With less time, I decided to make a new WiFi radome; this WiFi radome is mainly seen on B777, A350, B787, B767 and also on smaller airliners such as the B757, B737 and A319/A320/A321. The one that I tried to represent is the Honeywell’s Jetwave MCS 8200.

Some airliners using that WiFi radome are: A350 aircrafts, United’s B777, Lufthansa’s A320, ANA’s B767, 777 and 737, LOT 787, Air Europa B787 etc.

Following this antenna, I also would like to make the ADF antennas which are often included in both halves of the model’s fuselage and in my opinion, result in a little hasle when applying putty and sanding the fuselage union.

WiFi radome Read More

Making new molds

Hi all,

I am writing this entry to comment on the stock of the older GSE models. As you may probably know, sometimes molds can break or deteriorate with time because of several reasons; use, humidity etc. So right now I am in a transition process in which I am making new molds for the following items:

  • 1/144 Towbarless pushback.
  • 1/144 Catering truck.
  • 1/144 Cargo loader FMC15i.
  • 1/144 Ground power unit.
  • 1/144 LD3 containers.

I am obliged to make them new because using old molds means that there is going to be a loss of detail, so it should be important to renew the molds from time to time.

I am also re organizing in which way the parts will be casted so that I can:

a) Make the parts easier to prepare, by requiring less sanding lines.

b) To shorten the making process per unit.

Parts re arrangement for the new molds.

For the catering truck, I currently use 11 molds, but with a re arrangement I can use 7 molds.

Some of these modifications will represent a slight change in complex parts for casting, so these have been disassembled into two, but the final result will be the same. Therefore, a small update on the pushback truck, catering truck, and cargo loader instructons will be required.

The recent items:

  • 1/144 Belt loader.
  • 1/144 Carts (A and B).
  • 1/144 baggage.
  • 1/144 AKH containers.

Will be produced with their original and recent molds.

As for the Neo engines; I am preparing stock units of them so they will be available once the stock for the GSE items is completed so that the new online store can be opened with both these items available.

I would like to write a little bit on regards the airliner livery decals, but I currently can’t give much more info at the moment as tests haven’t been done yet for the A350 decals. I am currently designing the base decal for the Airbus A350 and at the same time designing a new type/style  of decals (I think) which will be tested on the A350 and for which I hope they will come out alright.

 

Best wishes,

Guillem

Making new molds Read More